Desk tops, markerboard panels, credenza glass, and screens for contract furniture programs. Drilled for standoffs, printed where you need a colored back, and tempered to the spec.
Polished-edge tempered tops with radius corners and grommet holes.
Low-iron panels with a frit-printed back for a permanent writing surface.
Satin or frit-banded panels for desk-mounted dividers.
Matching shelves and sliding cabinet lites from the same program.
| Max panel size | 90" × 144" |
| Thickness | 3/16"–1/2" (5–12 mm) |
| Glass types | Clear desks from stock. A privacy screen can be light gray, or satin etch ordered at 6 mm. Markerboards are low-iron, ordered, with frit fired on the back. |
| Edgework | Flat polish, pencil edge |
| Fabrication | Standoff and grommet holes, notches, countersinks |
| Decoration | Ceramic frit, 1–2 color, full or partial coverage |
| Size tolerance | ± 1/32" on cut size; squareness within 1/16" |
| Standards | ANSI Z97.1-2015 Class A · 16 CFR 1201 Category II (400 ft-lb) · permanent temper mark |
Need a spec not listed? We quote off your drawing. Colors we usually keep on hand.
DXF, DWG, PDF, a dimensioned sketch, or a photo of the part. We check holes and edge distances against the tempering limits before we price it, so the number is for a part we can actually make.
Start a quote →Missing something? Call the shop. You will reach someone who has run the furnace.
Yes. Low-iron glass with ceramic frit fired on the back. The color is in the glass, so it does not chip the way paint does or lift the way film does.
Yes, before tempering. Send the hole schedule with edge distances and we'll confirm they're temperable.
Frit colors are a set palette rather than an infinite match, but we'll get you the closest available and show it before the run.
A short note on the part is enough for a first number. Drawings and photos welcome.
