One-off glass for homes. A replacement cabinet lite, a table top with a polished edge, a set of shelves, a broken door panel. Bring dimensions, or bring the old piece.
Polished-edge tempered tops with radius corners, cut to your template.
Ground or polished shelf glass in 1/4"–1/2" (6–12 mm) for brackets and cabinets.
Replacement lites for cabinet doors, entry doors and sidelites.
Hearth panels, wall protection and other odd shapes cut on the CNC.
| Sizes | Any size to 90" × 144" |
| Thickness | 1/8"–1/2" (3–12 mm) depending on span and use |
| Glass on hand | Clear in 3–6 mm for a shelf, a top, or a replacement lite. Gray or bronze if you want a tint. 3 mm obscure for a cabinet or door. Thicker than 6 mm is ordered. |
| Edgework | Seamed, ground, flat polish or pencil edge |
| Corners | Square, clipped or radius |
| Size tolerance | ± 1/32" on cut size; squareness within 1/16" |
| Standards | ANSI Z97.1-2015 Class A · 16 CFR 1201 Category II (400 ft-lb) · permanent temper mark |
| Lead time | Typically under two weeks for one-offs |
Need a spec not listed? We quote off your drawing. Colors we usually keep on hand.
DXF, DWG, PDF, a dimensioned sketch, or a photo of the part. We check holes and edge distances against the tempering limits before we price it, so the number is for a part we can actually make.
Start a quote →Missing something? Call the shop. You will reach someone who has run the furnace.
No. Tempered glass cannot be cut, drilled, or edged after it leaves the furnace. Every hole and notch has to be on the drawing before we run it. Send the finished size. We cannot trim it later.
Yes. A cardboard or paper template is the safest way to match an odd opening, and you can drop it at the shop.
We fabricate; we don't install. We can point you toward installers who buy from us.
A short note on the part is enough for a first number. Drawings and photos welcome.
